ElectraStim Flick EM60-E Gen 2 is a rechargeable, single-channel electrostimulation controller. It provides 24 intensity levels, 10 programmed patterns, motion-responsive Flick mode, and angle-responsive Tilt mode. This EM60-E pack includes the controller, four self-adhesive ElectraPads, one 2 mm connecting cable, a USB-C charging cable, storage pouch, reset pin, quick-start guide, and warranty card.
Verified product details
| Maker | ElectraStim / Cyrex Ltd. |
|---|---|
| Model | Flick EM60-E Gen 2 |
| Store SKU | 8127-71 |
| Manufacturer model | EM60-E |
| UPC / GTIN | 609224031571 |
| Output | Single channel; one bi-polar or two uni-polar electrodes |
| Intensity | 24 levels with 12 dual-brightness indicators |
| Programs | 10 patterns, plus Flick and Tilt motion modes |
| Charging | USB-C; maker lists up to 3 hours to charge |
| Run time | Maker lists up to 6 hours per charge |
| Controller dimensions | 95 x 55 x 15 mm / about 3.74 x 2.25 x 0.75 in |
| Maker-listed controller weight | Approximately 300 g |
What is in the EM60-E pack?
- Flick EM60-E Gen 2 single-channel controller
- Four uni-polar self-adhesive ElectraPads
- Accessory connecting cable with two 2 mm pins
- USB-C charging cable
- Storage pouch, reset pin, quick-start guide, and warranty card
This is the EM60-E controller pack, not the EM60-M multipack. The ElectraProbe and ElectraLoops shown in some maker literature belong to the EM60-M package and are not listed as included here. Product design and pack contents can change; inspect the received package and follow its enclosed instructions and warranty terms if they differ from this page.
Controls and compatibility
The controller starts at intensity 0 on the continuous pattern. Connect the electrodes before applying stimulation, then raise intensity slowly. The central button cycles through 10 patterns. Holding it for three seconds enters Flick mode; pressing it again enters Tilt mode. Both motion modes reset intensity to 0 before you increase it.
The single output accepts either one bi-polar accessory or two uni-polar electrodes using the included 2 mm cable. Both uni-polar pads must contact the body to complete the circuit. Check the accessory maker's compatibility and instructions before connecting any other electrode; never assume that a connector alone proves safe compatibility.
Important electrostimulation limits
- ElectraStim directs users to apply stimulation only below the waist. Do not place electrodes across the chest or on the head, neck, or any above-waist area.
- Do not use with heart problems or arrhythmia, a pacemaker or other implanted medical device, metallic surgical implants, pregnancy, epilepsy, unexplained pain, inflamed, swollen, broken, or damaged skin, or a penile, vaginal, or anal disorder.
- Attach or insert electrodes before stimulation begins. Start at 0, increase slowly, and stop immediately for pain, burning, numbness, dizziness, unexpected muscle contraction, skin irritation, or any other adverse sensation.
- Keep the controller and all electrical connections dry. The controller is not waterproof: never immerse it or use it in a bath, shower, pool, or other wet setting.
- When sharing stimulation, the maker says all bodily contact must remain below the waist. Every participant must understand and be able to stop the session.
- This product is not a medical device, does not diagnose or treat a condition, and does not replace individualized medical advice. Ask a qualified clinician before use if you have a health condition, implanted hardware, reduced sensation, or uncertainty about electrical stimulation.
Charging, cleaning, and storage
Use the supplied USB-C cable and charge away from water. The maker says a full charge can take up to three hours and last up to six hours. A flashing red battery light signals charging or low power; it stays solid red when charging is complete.
Switch the controller off and disconnect accessories before cleaning. Wipe the controller with a lightly dampened cloth only; do not immerse it and keep moisture out of the output and charging sockets. Clean electrodes according to their own instructions, allow every part to dry completely, replace the clear backing on reusable pads, and store the dry controller and accessories in the pouch with cables loosely arranged. Inspect pads, leads, connectors, casing, charging port, and controls before each use and discontinue use if anything is cracked, frayed, loose, corroded, wet, or damaged.
Browse the ElectraStim collection, compare the electrostimulation category, explore electro power units, review pads and loops, see electro accessories, check shipping and discreet packaging, or read the returns, refunds, and hygiene policy.
